You can adjust the display of your project in a number of ways, including the type of camera to use, the way to shade surface, and whether or not to display incline lines for the batter slopes.
The Display panel provides controls which are used to adjust the display of the current phase.
It is important to note that lines and site plans are not currently displayed in either of the 3d views. For this reason, all controls which relate to the display of lines will be disabled when either of the 3d cameras are selected.
|
Camera Selector This dropdown allows you to choose the camera used to display the project. This is used to determine whether you are display in 2d or 3d modes. For more information see Cameras . |
|
Lighting Mode This dropdown allows you to choose the lighting which is used to display the project. Options include hard lighting, soft lighting and no lighting. |
|
Earthworks Shading Mode (Not in Existing Tab) This dropdown allows you to choose the method used to shade the proposed earthworks. Options include cut & fill, levels and match existing. |
|
Lines Display Mode (Not in Existing Tab) This dropdown allows you to choose the lines which are displayed for the proposed earthworks. Options include outlines only, outlines and include lines and no lines. |
|
Toggle Selection Lines (Not in Existing Tab) This button allows you to choose the turn the selection lines for the earthworks elements on and off. |
|
Toggle Grid Lines This button allows you to turn the grid lines on and off. |